Mix 15 ml Part A & B together. I use CCDIY Thin Viscosity for these.
1
Add enough glitter to your resin so that it is not see through.
2
Start pouring into your mold by gently spreading the opening of the mold. Wiping any over flow.
3
Continue adding to fill the rest of the mold. I pour off my popsicle stick for this step.
4
If you have extra fill a small mold so you have no waste.
5
Hit mold quickly with a heat gun to pop any bubbles.
6
After sitting for a few minutes you will notice a bit of settling. As well as the bubbles rising.
7
Pop any bubbles then top off your mold with a bit more resin to plump it up and prevent an indent.
8
If you have a small indent when you demold. Here’s how to fix it.
9
Mix a small amount of resin and with a pointed silicone brush add just enough to level out the edge.
10
Do this all the way around your bangle. Quickly torch. Once cured add your hardware.
11
What you'll need
Affiliate Disclosure: As an Amazon Affiliate, I may earn commissions from qualifying purchases.
Thin Viscosity
Buy
Bangle Mold
Buy
Heart Mold
Buy
1 Inch Binder Ring
Buy
Large Lobster Clasp
Buy
Tassel
Buy
Explore more Jumprope
Want to create? It’s fast, easy, free & open to anyone.
Learn more.
More than 50,000 step-by-step guides to learn how to do anything.