EMBROIDERED STRAW CLUTCH
Draw your design
1
Cut it out to use as a stencil
2
Trace your pattern using a water soluble pen & focusing on corners so it’s easier to see.
3
Use a backstitch to create an outline of the design. (Everything except the dots.)
4
Use a satin stitch to fill in each area. Sew through the outlines and don’t pull too tight.
5
To start a new section, insert the needle into the middle and leave a tail that you can tuck in.
Wrap thread 4-5 times around 2 fingers, tie tightly, tie it onto the bag, & fray/trim the strands.
6
Enjoy your custom clutch!
My shop
Check out the products I love
The Inside Hoop 3D Printed Earrings
Buy
In 1 guide
You Make Me Wanna Hoop 3D Printed Earrings
Buy
In 1 guide
Spin Off Custom 3D Printed Necklace
Buy
In 1 guide
What in Carnation? 3D Printed Earrings
Buy
In 1 guide
Don't Get Ruffled 3D Printed Earrings
Buy
In 1 guide
Get The Luck Out 3D Printed Necklace
Buy
In 1 guide
Not So Trivial 3D Printed Earrings
Buy
In 1 guide
Going Down Swinging Custom 3D Printed Necklace
Buy
In 1 guide
View full shop
Explore more Jumprope
Want to create? It’s fast, easy, free & open to anyone.
Learn more.
More than 50,000 step-by-step guides to learn how to do anything.