Felt Heart Earrings with Foil Iron-On
Felt
Foil Iron-On
Cricut Weeding Tool
HeatNBond
Felt
Foil Iron-On
Cricut Weeding Tool
HeatNBond
Cricut Easy Press Mini
Scissors
Jump Ring + Earring Hooks
Hole Punch 1/16th Inch
Samantha Upright Font
Buy
Design in DS. Hearts are from access images. Font is Samantha Upright. Link in supplies.
1
Duplicate: Four 2.25 in wide hearts for a front and a back. MIRROR the HTV mat.
2
Trim felt & HeatNBond to the size you’ll need to make the hearts. 3 inches by 10 inches.
3
Cut iron-on mat & apply HeatNBond to felt with EP Mini. Allow to cool before peeling off the back.
4
To cut felt: change material setting to “Felt, Craft Bonded” & change to Rotary blade.
5
Use scissors to carefully trim hearts out if needed & place them HeatNBond sides together.
6
Weed HTV design & align on top of double sided hearts. The heat will bond the 2 sides together.
7
Press on medium heat for 25 seconds & allow a few seconds to cool before removing the backing.
8
Replace clear film back over pressed designs, flip over, & press designs to the backs.
9
Allow to cool & remove all 4 backing pieces. (I used scrap felt over my mat. HeatNBond gets melty.)
10
Hole punch both hearts where you’ll apply the jump ring.
11
Use pliers to widen jump ring if needed & fish it through the hole. Add earring hook & close ring.
12
Thanks for watching!