DIY Personalized Rosette Ribbon Gift Topper
Make sure all of the wings are overlapped in the correct direction. Right wing over the left wing.
1
Insert the end of the ribbon underneath the plate. Then hold the ribbon in place with your thumb.
2
Make a fold with the ribbon and push it over the left wing, underneath the right wing.
3
Insert the ribbon into the same wing that you started with. Then trim the ribbon.
4
Place it over the beginning of the ribbon, tucked underneath the next wing.
5
Place the stickers at the center on both sides of the rosette, then firmly press them together.
6
Carefully remove the rosette from the maker by pushing the center of the rosette through.
7
Cut a fabric square that is 1/2 inch wider than the rosette center. Trim the square into a circle.
8
Stitch about 1/4” from the outside of the circle. Stitch all the way around the circle.
9
Place the center of the rosette inside the fabric circle. Then pull & knot the thread to secure it.
10
Add ribbon tails to the back of the rosette with craft glue.
11
Insert the pin though the felt circle.
12
Glue the felt circle onto the back of the rosette over the ribbons with craft glue.
13
Attach the fabric center to the front of the rosette ribbon with craft glue.
14
Make personalized rosette ribbons for your loved ones.
15
Attach your rosette ribbon to a package. Enjoy!
16
As an Amazon Affiliate, I may earn commission from qualifying purchases.
Clover’s Rosette Maker
Buy
Fabric
1” - 1 1/2” Thick Ribbon
Needle & Thread
Clover’s Rosette Maker
Buy
Fabric
1” - 1 1/2” Thick Ribbon
Needle & Thread
Sharp Scissors
Buy
Beacon’s 3-in-1 Advanced Craft Glue
Buy